Samples, Samples, Samples | |
|
When you are considering a trim removal system, keep in mind, your supplier should have the capability to test samples of your edge trim. This testing assists in determining system feasibility and best system sizing for your application. As a supplier of pneumatic edge trim removal systems, we deal with an extremely wide variety of webs and edge trims. Film, foil, foam, paper and board, woven and non-woven, adhesives, coatings, abrasives all behave differently in the air stream of a pneumatic waste removal system. We handle trim widths as narrow as .03" up to over 8". We may handle one, two or multiple trims. Matrix with exposed adhesive in widths over 25" wide can be efficiently handled with pneumatic waste removal systems. When sending samples to any potential supplier of your trim removal equipment, make sure those samples represent the range of application. From your lightest to heaviest trim. Most important is to supply samples of the heaviest, thickest, stiffest edge trim you want handled with the pneumatic waste removal system. Written By: Jeffrey Damour, Sales Engineer, Converter Accessory Corporation, Wind Gap, PA | |
|
**DISCLAIMER - A great deal of time has been invested in the development of our weekly tech tips. To the best of our knowledge, they are accurate. It is up to the user to verify all results. THE AUTHOR ASSUMES NO LIABILITY CONNECTED WITH THE USE OF THIS INFORMATION OR THE RESULTS OBTAINED FROM IT. | |
